Temperature monitoring
Internal or external temperature sensor variants, with stated error no more than 0.5 °C.
EDVADO HARDWARE
DOT BTS v6.1
Bluetooth temperature sensor with dry-contact state monitoring and internal or external probe variants.
≤0.5 °CTemperature error
IP67Enclosure protection
40–50 mOpen-space range
2700 mAhBattery capacity
Built for monitoring
Why DOT BTS v6.1
Bluetooth temperature sensor with dry-contact state monitoring and internal or external probe variants.
State detection
Dry-contact circuit monitoring alongside temperature data.
Wireless reporting
BLE broadcasting and iBeacon identification.
Mobile setup
Sensor Configurator app for configuration and diagnostics.
Specification information
Specifications are based on the available manufacturer manuals. Features not described in those documents are not confirmed.
Not specified: absent from sources. Not confirmed: catalog claim without a technical document. Not supported: explicitly excluded by the manufacturer.
User manual
Technical specifications
Specifications below are taken from the supplied device manual.
Body and measurement
- External version dimensions
- 77 × 95 × 35 mm; including mounting and cable gland
- Internal version dimensions
- 58 × 95 × 35 mm; including mounting and cable gland
- External version weight
- 125 g; including battery and wired temperature sensor (1 m cable)
- Internal version weight
- 105 g; including battery and wired temperature sensor (1 m cable)
- Temperature error
- ≤0.5 °C
- Operating temperature
- −55 to +85 °C (battery-limited)
- Enclosure protection
- IP67
Wireless and power
- Bluetooth
- 4.0–5.3
- Transmission power
- +6 dBm; programmable
- Wireless range (open space)
- 40–50 m
- Battery
- Replaceable ER14505
- Battery capacity
- 2700 mAh
- Current consumption
- 23 µA
- Estimated battery life
- 4.4 years — laboratory estimate; actual life depends on battery manufacturer/age, advertising packet/interval and radio power
- Dry-contact monitoring
- Supported
- Identification
- iBeacon
Additional specifications
- External temperature interface
- 1-WIRE; three-wire sensors with separate power, or two-wire sensors without using the sensor power terminal
- Supplied temperature sensor cable
- 10–50 cm; can be extended or shortened
- BLE transmission formats
- Closed connection; Open advertising (Escort TL format); Mini advertising
- Circuit input restriction
- Do not apply voltage to circuit-monitoring wires; disconnect battery before connecting sensors or monitoring circuits
- Configuration and diagnostics
- Sensor Configurator mobile app
DOT BTS v6.1
Support for DOT BTS v6.1
The original manual is available in English as a PDF.
Get StartedConnection and setup
- Disconnect the battery before connecting an external temperature sensor or monitored circuit.
- Do not apply voltage to the circuit-monitoring wires.
- Observe battery polarity when installing or replacing the battery.
- Use the Sensor Configurator mobile app with Bluetooth and location enabled.
Knowledge BaseTechnical information
The manual describes internal and external temperature variants, dry-contact wiring, BLE broadcast modes, configuration and battery replacement.
View specifications →